Monster FlatScreen SuperThin Tilt Mount - Up to 27” Screens - Manual (Page 16)

16
attaching your Flatscreen TV
to the TV mounting Plate
DO NOT lay your TV face down when
attaching the TV mounting plate. This
can cause permanent damage to your
screen. Lean it against a wall or other
solid surface so it remains vertically
upright.
DO NOT over tighten screws. Thread
screws carefully by hand before
tightening. If you feel any resistance,
remove the screw immediately.
The television should be unplugged
before threading any bolt or screw into
the back panel.
1
Locate the threaded inserts on your TV’s
back panel.
2
Note the two sets of mounting holes on your
TV mounting plate. Determine which set aligns
perfectly with the four threaded inserts on your TV’s
back panel.
3
By hand, thread the screws through the
mounting plate’s mounting holes into the four
TV inserts.
4
With a Phillips screwdriver, tighten the screws
so the TV mounting plate is securely attached
to the TV.
Your mounting system features two sets of screws,
M4×15 and M5×15. The M5×15 is the thicker of the
two. Determine which set of screws is the correct
length for your TV’s inserts. Test one of the screws to
ensure it’s the correct choice.