Monster PRO 600 - Manual (Page 8)

8 9
TROUblesHOOTInG
symptom Possible Cause Remedy
Component is
not receiving power . The component is plugged into a switched outlet
and the PowerCenter has not been turned On . • Turn the PowerCenter On.
• Or, plug the component
into an Unswitched outlet .
The PowerCenter is plugged into a Switched
outlet, but power on the component is not On .
In some instances, a component plugged
into a switched outlet won’t receive power
when the PowerCenter is turned On unless
the component power is also switched On . • Turn the component power On.
Speakers emit
a humming or
buzzing noise . The PowerCenter is sharing AC power
with equipment that is not properly grounded . • Connect your PowerCenter
to a dedicated outlet .
• Try unplugging different components
from the PowerCenter one at a time
to see if the noise stops . If a component
is discovered to be improperly
grounded, attach a copper wire from
the component’s chassis to the
PowerCenter’s grounding post .
TROUblesHOOTInG
symptom Possible Cause Remedy
Video picture
has rolling bars
or ghosting . The incoming video signal
is not properly grounded . • Contact your cable or satellite provider
to correct your installation .
The PowerCenter
is emitting a loud
buzzing alarm . The PowerCenter protection circuitry
has sacrificed itself to protect connected
equipment from a catastrophic surge . • The PowerCenter must be replaced.
See the Warranty Information section
for important details .