Memphis MXA-LED - Manual (Page 2)

16-MXALEDSP2 and 16-MXALEDSB1
Installation:
Attach LED ring to the back of the Speaker or Subwoofer grill with supplied double
sided tape. Run wires down the lower right spoke of the grill/s. Cyanoacrylate glue may be used to
secure wires to back of the grill. Cut a notch on the lower right side of speaker basket, if not already
notched. Make sure that wiring is protected and not pinched during installation. The 16-MXALEDSP2
and 16-MXALEDSB1 can be controlled by the 16-MXALEDCTR or wired directly for single color use. To
use the 16-MXALEDCTR, Connect supplied pigtail harness to the 16-MXALEDCTR’s supplied pigtail
harness. If not using the 16-MXALEDCTR, make sure to connect the Black wire of the supplied pigtail
harness to a switched + 12V fused source and use the chart above to determine the color of wire/s to
connect chassis ground to for the appropriate LED color desired.