DeVillbiss Air Power Company DAPC D25690 - Manual (Page 13)

13- ENG D25690
How To Change Pump Oil
1. Loosen oil fill cap.
2. Place a container under the oil drain
plug.
3. Remove oil drain plug.
4. After oil is drained replace oil drain plug.
Tighten securely.
5. Remove oil fill cap and fill with
recommended oil. See the Pump Oil
Chart for the correct amount and type of
oil.
6. Replace oil fill cap and tighten securely.
When performing maintenance, you may be exposed to hot
surfaces, water pressure, moving parts, or fire that can cause
serious injury or death!
Before performing any maintenance or repair, disconnect spark plug wire, let
engine cool and release all water pressure. The engine contains flammable
fuel.
DO NOT smoke or work near open flames while performing maintenance.
To ensure efficient operation and longer life of your pressure washer, a routine
maintenance schedule should be prepared and followed. If the pressure washer is
used in unusual conditions, such as high-temperatures or dusty conditions, more
frequent maintenance checks will be required.
ENGINE
Consult the Engine Owners Manual for the manufacturer's recommendations for
any and all maintenance.
MAINTENANCE
PUMP
NOTE: The pump was filled with oil at the
factory.
1. Change pump oil after the first ten (10)
hours of operation and every fifty (50)
hours thereafter.
Oil Fill Plug
Oil Drain Plug
DAPC Axial Cam
**Annovi Reverberi (XMV)
DAPC (axial cam)
30W non detergent
* R&O 150
13.5 oz.
8 oz.
* If unable to find use 30 W non detergent
** See nameplate located on pump to determine Annovi Reverberi type
**Annovi Reverberi (RKV) 30W non detergent 18.54 oz.
Oil Fill Plug
Oil
Drain
Plug
Sight Glass
Annovi Reverberi
PUMP TYPE OIL TYPE OIL CAPACITY
PUMP OIL CHART
Nameplate