Mega Catch MCA-600 Alpha - Manual (Page 3)

The Mega-Catch™ ALPHA Mosquito Trap can be used
indoors or outdoors.
Place your ALPHA Trap on a flat surface approximately
2 to 3 feet (0.75 - 1metre) above floor or ground level.
Alternatively, install a metal ring (keyring loop) through
the hole on the lid, and hang or suspend the trap so
it is approximately 2 to 3 feet (0.75 - 1metre) above
floor or ground level.
Place the trap in a shaded area, protected from strong
wind. Place the trap as far away from people and as
close to the mosquito source as possible.
If severe weather conditions are predicted then store the Trap out of the weather.
Trap Siting
Features of Mega-Catch™ ALPHA Mosquito Trap
The Mega-Catch™ ALPHA Mosquito Trap has been designed for indoor or outdoor use.
The ALPHA can operate unattended for long periods. It features an electronically controlled LED lighting
system that produces intermittent light at oscillating frequencies selected to coincide with spectral
sensitivity peaks for many mosquito species.
Mosquitoes attracted to the ALPHA by visual and other cues enter the Trap where they are collected
in the Catch Bag.
Specifications
Power Source AC/DC Adaptor EPA Reg. No.: 70909-3-74943
UL Listing 48ST E198424 U.S. Patents Pending
Input 120V AC 60HZ 30W U.S. Trade Mark Reg. No: 2,679,688
Output 12V DC1.2A
Pub. No. 1000000007 Printed in China
Mega-Catch™ is a trademark of Envirosafe Technologies NZ Ltd.
MADE IN CHINA for:
Envirosafe Technologies NZ Limited
16th Floor, 120 Albert Street
Auckland, New Zealand
[email protected] www.megacatch.com