MBM Corporation F45N automatic tabletop folder - Manual (Page 8)

-7-
(4) Operation Panel And Functions
F - 4 5 N
306A
No. Designation/Indication Function
1 Fold type key Six folding types can be input and stored.
2 Test key Test folds two sheets without counting.
3 Start/Stop key Operation, if pushed again the machine stops.
4 Clear/Reset key Clears counter indication and resets error.
5 Store key Fold position after adjustment is stored.
6 Memory 1/2/3 key Three special folding types are stored. (Only for F-45N)
7 Select key
Used for selecting the indication of the counter,
the position of the stopper stud of Table 1 and 2,
the position of paper eject roller, paper length.
8 Perforation mode lamp
It lights when the optional perforating unit is
installed.
9 + /? key
Used for adjusting the position of the stopper of Table
1 and 2, the position of paper ejection roller, paper
length
10 Speed adjustment key Used for adjusting the speed.
11 Numerical key
Used for inputting a number of sheets to be folded
and the length of non-standard-size paper
12 Counter
Shows the number of sheets, the position of the
stopper pin of Table 1 and 2, and paper size.
13 Check lamp
It lights when pa per stock runs short, or indicates the
location where paper feed trouble occurs.
14
Table 1 stopper move mode
lamp It lights when the position of stopper of Table 1 is
adjusted.
15
Table 2 stopper move mode
lamp It lights when the position of stopper of Table 2 is
adjusted.
16 Paper ejection roller move
lamp
It lights when the position of the paper ejection roller
is adjusted. (Only for F-45N)
17 Paper length input mode lamp It is on when paper length is input (only for F-45N)
18 Counter input mode lamp It lights when reduction is indicated on the counter.
19 Paper size input mode
lamp
It lights when paper size is indicated.