MBM Corporation Booklet-Pro 7500 - Manual (Page 9)

TRIMMER MODEL 89-75 OPERATOR MANUAL
03/97
T10069
3.3 Adjusting the cutting margin
The pre-set sizes are set for an approximately 4mm cut of the middle
sheet of the booklet. This can easily be adjusted by pressing the adjust-
ment buttons to increase or decrease the cutting margin. By pressing and
holding the button down the trimmer stop will move continuously, if
pulsing the button the trimmer stop will move for approximately 0,5mm.
Adjustments
1 Press this button to increase the trim
2 Press this button to decrease the trim
NOTE: Use the below table as a reference when setting the
cutting margin.
3-3
Number of sheets per booklet Amount of trim Adjustment procedure
2 through 5 sheets. 4 mm.
Default setting is 4 mm. No
adjustment required.
6 through 10 sheets. 5 mm.
Press the adjustment button two
times to increase the trim.
11 through 15 sheets. 6 mm.
Press the adjustment button four
times to increase the trim.
16 through 20 sheets. 7 mm.
Press the adjustment button four
times to increase the trim.