MBM Corporation 102 - Manual (Page 10)

T10087 February 1999
Stapler Folder Model 102 Operator Manual
The A3 button for 297 x 420 mm. - Position the output wheel at the
middle notch.
The A4 button for 297 x 210 mm. - Position the output wheel at the
innermost notch.
The A5 button for 148 x 210 mm. - Position the output wheel at the
innermost notch.
The * button for customised size. - Position the set output wheel
appro. 50 mm from the leading
edge of the first set.
U.S. paper
sizes
or
3.2 Setting up the Model 102, continues
NOTE1: If the distance between the stapler and the side jogger is to
narrow, the staplers or side joggers incorrectly positioned indi-
cator will be illuminated (also see section 3.7.). Make sure the
distance between the actuator and the switch is no less than 8
mm.
NOTE2: Depending of the previous job setup you might have to select
paper size program before you move the staplers apart.
The anvil position scale indicates the distance, in millimetres, from centre
to centre (cc) of the staples.
Type of finishing Paper format Setting (cc)
booklet making 5,5”, CD 98
booklet making A5 105
booklet making 8,5”, A4 120
booklet making 11”, A3 120 or 200
side stapling 11”, A4 144 (Recommended)
corner stapling 11” 255 (Recommended)
corner stapling A4 273 (Recommended)
NOTE: Using other settings could result in poor staple/fold result.
Select a paper size program
For your convenience, the A3, A4 and A5 (8.5"x11", 8.5x14", 11"x17" and
5.5”x8.5”) paper size programs were factory set with appropriate jogging,
staple position and fold line position. The jogging, staple position and the
fold line position may need fine adjustments depending on the type of
paper used.
NOTE: If you want to use a custom format, select the next bigger (dis-
tance between the lead edge and the trail edge) paper size pro-
gram. Fine adjustments will be explained in section 3.3 and 3.4.
7 Press the appropriate button to select paper size program.
lead
edge trail
edge
3-3
min 8 mm
min 8 mm