MBM Corporation 49 - Manual (Page 10)

T10114 Jan 2001
Sheet Feeder Model 49 Operator Manual
2.4 Explanation of the Menus, cont.
LANGUAGE
DIAGNOSIS
PLACEMENT (1)
LANGUAGE
EJECT SPEED
TRIG DELAY
ES: 100%
LUG SPEED
EJECT SPEED
LS: 70%
TRIG DELAY
SETS PER HOUR
TD: 50 ms
Belt speed is how fast each document will be fed. Enter a
percentage using the arrow buttons. The range is 60 to
100%. Default value is 80%. If the belt speed is too slow the
documents might have problems to ”leave” the Model 49. If
the belt speed is too high, single sheets might turn over
when they are fed and booklets might bounce back.
Lug speed is how fast each set of documents will be fed
into Model 45. The range is 30 -140%. Default value is
70%.
Eject speed is a speed up function of the Lug speed. The
range is 30-140%. Default value is 100%. The value should
not be set under the “Lug Speed” value.
Trig Delay is a delay of the signal, which is sent as a start
signal to next machine in order. The range is 30-1000 ms.
Default value is 50 ms.
When entering the menu “Default setup” and pressing the
OK button the “Belt Speed”, “Lug speed”, “Eject speed” and
“Trig Delay” will have their default values.
Enter the “Placement” with OK button to set the place of the
machine in the line. The placement number of the machine
is depending on how many machines are in use.
See chapter 7.2 for more information.
Select language by pressing OK button. The languages
available in the system are Deutsch, English, Francais and
Svenska.
Default language is English.
2-7
BELT SPEED
LUG SPEED
BS: 100%
DEFAULT SETUP
BELT SPEED