Maytag MDB8751AWB - Manual (Page 12)

11
Lights/Display
(select models)
INDICATOR DESCRIPTION
Time Remaining Display
(select models)
Clean Light
Drying Light
(select models)
Washing Light
(select models)
Heating Delay Light
(select models)
Sanitized Light
(select models)
Shows approximate minutes remaining in a cycle. The symbol “2H” will appear when
cycle time is greater than 99 minutes. Cycle times shown in the numerical display
(select models) will increase or decrease, based on each load’s soil level, water
temperature and selected options.
Illuminates at the end of the cycle and remains lit until the door has been open for 30
seconds continuously.
Illuminates during the entire dry period and goes out when the cycle is completed.
Illuminates during all rinse and wash portions of the cycle.
Illuminates when cycle is being extended to heat the water.
Illuminates at the end of the cycle when conditions have been met to achieve
sanitization. The light will remain lit until the door has been open for 30 seconds
continuously.
Notes
• When Sanitize is selected, cycles are monitored to assure sanitization. The Sanitized light will not activate if
sanitization requirements are not met. This could happen if the cycle is interrupted, power failure occurs or
incoming water temperature is below 120° F (49° F).
• The Clean and Sanitized indicator lights (select models) will not relight after a power failure until after the next cycle
is run.
Cycles, Options and Lights