Maytag MMV5207ACQ Installation - Manual (Page 7)

Parts, Tools, Materials
7
You will need the following tools and materials for the installation:
Carton or other heavy material for covering the counter top.
Clear Tape
(for taping the templates to the wall)
Stud Finder or Thin Nail
Saber Saw
(for cutting vent holes for roof
or wall vending)
Phillips Screwdriver
(for the screws)
Pencil
Flat Blade Screwdriver
(for the toggle bolts)
Measuring Tape
(metal preferred)
Small Side Cutters or Tin Snips
Keyhole Saw (for the power cord hole)
3/8" and 3/4" wood drill bits
1/2" and 3/16"
drill bits
Plumb Line
Duct Tape
Caulking Gun
Electric Drill
● If you have brick or masonry walls, you will need special hardware and tools.
● The ductwork you need for the installation is not included. All wall and roof caps must have a back-draft damper.
(Shown on page 6).