Maytag MMV6190DS - Manual (Page 3)

3
Electrical Requirements
Observe all governing codes and ordinances.
Required:
■ A 120 volt, 60 Hz, AC only, 15- or 20-amp electrical supply with a
fuse or circuit breaker.
Recommended:
■ A time-delay fuse or time-delay circuit breaker.
■ A separate circuit serving only this microwave oven.
Settings
Clock
The Clock is a 12-hour (12:00-11:59) or 24-hour (0:00-23:59) clock.
Touch CLOCK/OPTIONS to reach Clock submenu, and follow the
prompts to set the clock. Clock format (12 hours with AM and PM or
24 hours) may also be set in the Clock submenu.
Kitchen Timer
With the microwave oven in standby mode, touch the Kitchen Timer
control, enter time, then touch the Kitchen Timer control or the Start
control. Cook functions may be entered while the Kitchen Timer is
counting down. To cancel timer, touch Kitchen Timer control while the
timer countdown is active in the display.
Control Lock
Activate to avoid unintended start. Touch and hold the Cancel control
for about 3 seconds until 2 tones sound and padlock icon appears in
the display. Repeat to unlock control.
Clock/Options
Ten options/settings may be adjusted: 1-Clock and Energy Save;
2-Scrolling Speed; 3-Sound; 4-Language (English or French); 5-Filter
Reset; 6-Fan Timer; 7-Light Timer; 8-Calibrate Temp; 9-Demo Mode;
10-Factory Reset.
Energy Save
To conserve energy, the Clock will automatically turn off when the
microwave oven goes into standby mode. Touch CLOCK/OPTIONS to
reach the Clock and Energy Save submenu, and follow the prompts to
turn on Clock.
Scroll Speed
Scroll speed of the text may be adjusted. Touch the CLOCK/OPTIONS
to reach the Scrolling Speed submenu, and follow the prompts to set
speed.
Sound (Tones)
Programming tones and signals. Key beep tones may be turned off, or
all tones (including end-of-function signals) may be turned off. Touch
CLOCK/OPTIONS to reach the Sound submenu, then follow the
prompts to turn off or on the programming tones or all tones.
Language (on some models)
Language of the display text may be changed. Touch the CLOCK/
OPTIONS to reach the Language submenu, and follow the prompts to
set language to English or French.
Filter Reset
Reset the filter status after replacing and/or cleaning the filters. Touch
CLOCK/OPTIONS to reach the Filter Reset submenu, and activate
reset.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING GROUNDING INSTRUCTIONS
SAVE THESE INSTRUCTIONS
■ For all cord connected appliances:
The microwave oven must be grounded. In the event of
an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric
current. The microwave oven is equipped with a cord
having a grounding wire with a grounding plug. The plug
must be plugged into an outlet that is properly installed
and grounded.
WARNING:
Improper use of the grounding plug can
result in a risk of electric shock. Consult a qualified
electrician or serviceman if the grounding instructions are
not completely understood, or if doubt exists as to whether
the microwave oven is properly grounded.
Do not use an extension cord. If the power supply cord is
too short, have a qualified electrician or serviceman install
an outlet near the microwave oven.
This device complies with Part 18 of the FCC Rules.
OPERATING YOUR MICROWAVE OVEN