beautypg.com

Flash-to-pass, Map/reading lights – Dodge 2009 Caliber User Manual

Page 132

background image

Flash-to-Pass

You can signal another vehicle with your headlights by
lightly pulling the multifunction lever toward you. This
will cause the headlights to turn on at high beam and
remain on until the multifunction lever is released.

NOTE:

If the multifunction lever is held in the flash-to-

pass position for more than 30 seconds, the high beams
will shut off. If this occurs, wait 30 seconds for the next
flash-to-pass operation.

Map/Reading Lights

These lights are mounted between the sun visors above
the rearview mirror. Each light is turned on by pressing
the button. Press the button a second time to turn the
light off. The lights also come on when a door is opened
or the dimmer control is turned fully upward, past the
second detent.

NOTE:

The lights will remain on until the switch is

pressed a second time, so be sure they have been turned
off before leaving the vehicle. The lights will turn off
automatically 10 minutes after the ignition is turned OFF
if the door is left open or light is switched on.

Map/Reading Lights

130

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

This manual is related to the following products: