Maytag MB1927PEHB - Manual (Page 5)

4
How to remove and
replace doors and
hinges
➢ Contact a qualified engineer to
perform this task.
Removing fresh food
front-mounted handle
➢ Remove top handle trim
by removing top handle
screw.
• Retain trim and screw
for later replacement.
➢ Pry bottom handle trim from
handle with screwdriver flat
blade wrapped in masking
tape.
• Retain trim for later
replacement.
➢ Removing two remaining
handle screws and
remove handle.
• Retain screws for later
replacement.
NOTE: Side-mounted fresh food
handles are available in kits for some
models. Please see your dealer for
details.
Removing freezer handle
Removing handle may be necessary
when transporting refrigerator through
tight spaces or when reversing door.
➢ Remove handle screws with Phillips
screwdriver.
• Retain screws for later replacement.
FOR PULLOUT DRAWER
ONLY:
1. Turn both stabilizing legs clockwise
until firmly against floor. Turn roller
adjustment screws 2 to 3 times
counterclockwise so that the full weight
of refrigerator rests on stabilizing legs.
➢ To avoid damage to walls and
flooring, protect soft vinyl or other
flooring with cardboard, rugs or
other protective material.
➢ To avoid damage or breakage to
adjusting bolt, do not use power
tools to correct leveling.
➢ DO NOT adjust refrigerator down
to where the base of the
refrigerator which supports the
condenser is resting on the floor.
Doing so may damage underside
components.
CAUTION
Roller
Adjustment
Screw
Stabilizing
Leg
2. Replace toe grille and bracket
cover(s). See markings on inside of
toe grille to insure proper placement.
• Snap bottom portion into place
first. Press down on top of grille
until top portion snaps into place.
What if my refrigerator
rocks?
➢ Turn rear adjustment screw clockwise
to raise rocking corner.
➢ Replace toe grille.
TOOLS NEEDED:
• 3 ⁄
8
" hex head driver
• Level
1. R e m o v e
toe grille
and bottom
hinge covers.
2. Turn both front
adjustment screws (A) clockwise to
raise and counterclockwise to lower.
3. Turn both rear adjustment screws (B)
clockwise to raise and counterclock-
wise to lower.
4. Check with level to verify 6 mm tilt to
the back for proper door closure.
➢ If refrigerator is aligned and stable,
replace toe grille.
How to level your
refrigerator
A
B