Maytag MSD2269KEA - Manual (Page 12)

12
PERFORMANCE DATA SHEETS
Base Grille Water Filtration System
Model WF-NLC240V/NLC240V Capacity 240 Gallons (908 Liters)
This system has been tested according to NSF/ANSI Standards 42 and 53 for the reduction of the substances listed below. The
concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the
permissible limit for water leaving the system, as specified in NSF/ANSI Standards 42 and 53.
Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.5 gpm (1.9 Lpm). Pressure = 60 psig (413.7 kPa).
Temp. = 63°F (17.2°C).
■ It is essential that operational, maintenance, and filter
replacement requirements be carried out for the product to
perform as advertised.
■ Flush for 5 minutes prior to use.
■ Model WF-NLC240V: Change cartridge at least every
6 months. Use replacement cartridge NLC240V, part
#8212652. 2006 suggested retail price of $39.99 U.S.A./
$44.99 Canada. Prices are subject to change without notice.
■ The product is for cold water use only.
■ Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after
the system. Systems certified for cyst reduction may be used
on disinfected waters that may contain filterable cysts.
■ Refer to the front cover or “Accessories” section for the
Manufacturer’s name, address and telephone number.
■ Refer to the “Warranty” section for the Manufacturer’s limited
warranty.
■ Note that while the testing was performed under standard
laboratory conditions, actual performance may vary.
Application Guidelines/Water Supply Parameters
System tested and certified by NSF International against NSF/ANSI
Standard 42 for the reduction of Chlorine Taste and Odor, Nominal
Particulate Class I*; and against NSF/ANSI Standard 53 for the reduction
of Lead, Mercury, Atrazine, Benzene, Toxaphene, p-dichlorobenzene, 2,
4-D, Cysts, Turbidity and Asbestos.
Substance Reduction
Aesthetic Effects NSF Reduction
Requirements Average
Influent Influent Challenge
Concentration Maximum
Effluent Product
Water Minimum %
Reduction Average %
Reduction
Chlorine Taste/Odor
Nominal Particulate Class I
*
≥
50%
≥
85%
2.1 mg/L
5,366,667/mL 2.0 mg/L ± 10%
At least 10,000
particles/mL 0.06 mg/L
4,100/mL** 0.05 mg/L
2,300/mL 97.1%
99.3% 97.6%
99.9%
Contaminant
Reduction NSF Reduction
Requirements Average
Influent Influent Challenge
Concentration Maximum
Effluent Product
Water Minimum %
Reduction Average %
Reduction
Lead: @ pH 6.5
Lead: @ pH 8.5 0.01 mg/L
0.01 mg/L 0.152 mg/L†
0.143 mg/L† 0.15 mg/L ± 10%
0.15 mg/L ± 10% 0.001 mg/L
0.001 mg/L 0.001 mg/L
0.001 mg/L 99.34%
99.30% 99.34%
99.30%
Mercury: @ pH 6.5
Mercury: @ pH 8.5 0.002 mg/L
0.002 mg/L 0.0061 mg/L
0.0057 mg/L 0.006 mg/L ± 10%
0.0058 mg/L ± 10% 0.0004 mg/L
0.0008 mg/L 0.0002 mg/L
0.00051 mg/L 93.5%
85.8% 96.7%
91.2%
Benzene 0.005 mg/L 0.0162 mg/L 0.015 ± 10% 0.0005 mg/L 0.0005 mg/L 96.3% 96.3%
p-dichlorobenzene 0.075 mg/L 0.220 mg/L 0.225 ± 10% 0.0005 mg/L 0.0005 mg/L 99.7% 99.7%
Toxaphene 0.003 mg/L 0.014 mg/L 0.015 ± 10% 0.0014 mg/L 0.001 mg/L 90.0% 92.9%
Atrazine 0.003 mg/L 0.0086 mg/L 0.009 mg/L ± 10% 0.0005 mg/L 0.0005 mg/L 94.25% 94.25%
2, 4-D 0.07 mg/L 0.197 mg/L 0.210 ± 10% 0.058 mg/L 0.0137 mg/L 70.6% 93.06%
Asbestos 99% 26 x 10 7 10 7 to 10 8 fibers/L†† 0.18 x 10 7 mg/L 0.18 x 10 7 mg/L 99.93% 99.93%
Cysts‡
Turbidity 99.95%
0.5 NTU 111,000/mL
11.00 NTU 50,000/L min.
11 ± 1 NTU 1 mg/L
0.4 NTU 1 mg/L
0.35 NTU 99.99%
96.4% 99.99%
96.8%
Water Supply
Water Pressure
Water Temperature
Service Flow Rate City or Well
30 - 120 psi (207 - 827 kPa)
33° - 100°F (0.6° - 37.8°C)
0.5 gpm (1.9 L/min.) @ 60 psi
*
**
†
††
‡
Class I particle size: >0.5 to <1 um
Test requirement is at least 100,000 particles/mL of AC Fine Test Dust.
These contaminants are not necessarily in your water supply. Performance may vary based on local water conditions.
Fibers greater than 10 um in length
Based on the use of Cryptosporidium parvum oocysts
® NSF is a registered trademark of NSF International.