Directed Electronics 600/5 User Manual

Page 9

FIGURE 2—AMPLIFIER CONNECTIONS 600/5 REAR

1. SSuubb OOuutt TTeerrm

miinnaallss - Connect

subwoofers to these terminals.
(Refer to the

Speaker Wiring

Diagrams section of this guide.)

2. SSppeeaakkeerr OOuutt TTeerrm

miinnaallss - Connect

the speakers to these terminals.
(Refer to the

Speaker Wiring

Diagrams section of this guide.)

3. PPoow

weerr FFuusseess -- These fuses protect

the amplifier against internal elec-
trical damage and are meant to
protect the amplifier only. All other
power connections should be fused
at the source.

4. ((++)) 1122 VVoolltt PPoow

weerr - Connect this

terminal through a FUSE or CIRCUIT
BREAKER to the positive terminal of
the vehicle battery or the positive
terminal of an isolated audio
system battery.

WAARRNNIINNGG:: Always protect this power wire by installing a fuse

or circuit breaker of the appropriate size within 12
inches of the battery terminal connection.

5. RReem

moottee TTuurrnn OOnn - This terminal

turns on the amplifier when (+) 12
volt is applied to it. Connect it to
the remote turn on lead of the head
unit or signal source. If a (+) 12
volt remote turn on lead is not
available, Remote Power Adapter
(P/N #55000) can be used to
supply a remote turn on signal. DO
NOT connect this terminal to
constant (+) 12 volt.

6. GGrroouunndd -- Connect this terminal

directly to the sheet metal chassis
of the vehicle, using the shortest
wire necessary to make this
connection. Always use wire of the
same gauge or larger than the (+)
12 volt power wire. The chassis
connection point should be scraped
free of paint and dirt. Use only
quality crimped and/or soldered
connectors at both ends of this
wire. DO NOT connect this terminal
directly to the vehicle battery
ground terminal or any other
factory ground points.

REAR PANEL CONNECTIONS