Marantz Mount 12 User Manual

Page 2

Step 5

Raise the projector with the mounting bracket (E) and slip through the
hinge pin slot openings on the bracket into the base box (H). Loosely
install the two (2) hinge pin screws (J), conical spacers (L) and flat
washers (K) and the angle locking screws (I). Adjust the angle and lock
it. Then tighten the hinge pin screws (J). Do not over tighten
See Figure 3

Check all hardware for proper tighten and security.

-_LA 061801_-

The ceiling should be capable of supporting a weight of

at least five (5) times the projector(s) or monitor(s)weight.

If it cannot, the ceiling must be reinforced. Proper

installation procedure by qualified personnel as outlined

in the installation instructions must be adhered to.

Failure to do so could result in serious personal injury.

DESCRIPTION/HARDWARE

A. MOUNT12 Mounting Bracket (1ea)
B. 6 (mm) x 20 (mm) Phillip Screws (2ea)
C. 6 (mm) Quick Release Sleeves (2ea)
D. 6 (mm) x 12 (mm) Knurl Knob (1ea)
E. Projector (Not Supplied)
F. Ceiling Structure (See Warning Label)
G. Suitable Hardware (Commercially Available)
H. PBB-10RL Base Box/Jam Screw (1ea)
I. 6 (mm) x 12 (mm) Angle Locking Screws (2ea)
J. 6 (mm) x 12 (mm) Hinge Pin Screws (2ea)
K. Flat Washers (2ea)
L. Conical Spacers (2ea)

M. EXT81 Adjustable Suspesion Adapter (Optional)

N. Suspension Adapter Ajustable Pins (2ea)

For further information or ordering assistance

on the front of this page.