Marantz VP8000 - Manual (Page 5)

4
INTRODUCTION
ENGLISH
z COMPONENT VIDEO IN
Y, P B /C B , P R /C R connectors.
Connect to the COMPONENT VIDEO output of video
equipment or an A/V processor/receiver with a component
video loop.
x S-VIDEO IN
Connect to the S-VIDEO output of a video equipment.
c VIDEO IN
Connect to the composite video output of a video equipment.
v RGB IN
Connect to the analog RGB output of a computer equipment.
b REMOTE SW. (EXTERNAL / INTERNAL)
When using the MARANTZ REMOTE CONTROL system, select
EXTERNAL. Otherwise select INTERNAL.
n REMOTE CONTROL IN / OUT
Connect to the REMOTE CONTROL connectors of other
Marantz equipment. It is then possible to control the whole
system with a single Remote Controller.
m TRIG. OUT (DC jack)
When the projector is turned on, a 12 volt signal is sent to the
equipment connected to the trigger. This allows automatic
triggering of an accessory, such as a powered up/down
screen, whenever the projector is turned on or off.
When the unit is turned off, no voltage is output and when the
unit is turned on, 12 V is output.
Note
You cannot use the connector as the power source.
, Adjuster button
When using adjuster, press the button and loosen an adjuster.
. Adjuster
⁄0 Rear adjuster
Adjust the vertical angle of the projector.
⁄1 Ventilation holes
⁄2 IR sensor
⁄3 AC IN
Connect the supplied AC power cord.
P R / C R RGB IN S-VIDEO IN
OUT IN
REMOTE SW REMOTE CONTROL
EXTERNAL INTERNAL
P B / C B Y TRIG.OUT
VIDEO IN
COMPONENT VIDEO IN
n b c . ⁄2 ⁄1
m v z x
⁄3 ⁄0 ⁄1 . .
,
Connector panel and Rear