Delta AP300 - Manual (Page 14)

14
STARTING AND STOPPING
DUST COLLECTOR
1. The on/off switch (A) Fig. 24 is located on the front
of the machine. To turn the machine “ON”, move the
switch up to the “ON” position.
2. To turn the machine “OFF”, move the switch (A)
down to the “OFF” position.
MAKE SURE THAT THE SWITCH IS IN
THE “OFF” POSITION BEFORE
PLUGGING IN THE POWER CORD. IN THE EVENT OF A
POWER FAILURE, MOVE THE SWITCH TO THE “OFF”
POSITION. AN ACCIDENTAL START-UP CAN CAUSE
INJURY.
LOCKING SWITCH IN
THE “OFF” POSITION
IMPORTANT: When the machine is not in use, the
switch should be locked in the “OFF” position to
prevent unauthorized use. To lock the machine, grasp
the switch toggle (B) Fig. 25, and pulling it out of the
switch as shown. With the switch toggle (B) removed,
the switch will not operate. However, should the switch
toggle be removed while the machine is running, it can
be turned “OFF” once, but cannot be restarted without
re-inserting the switch toggle (B).
Fig. 24
Fig. 25
A
B
OPERATION
For operator safety, make certain the dust intake port is covered with the hose before operating the machine.
The rotating fan inside the blower housing is accessible through the dust intake port and is hazardous. Make sure intake cap
covers the intake port when hose is removed. Always wear proper apparel. Do not wear jewelry and keep fingers and all foreign
objects out of the dust intake port. Always follow the safety rules of this manual.
OPERATIONAL CONTROLS AND ADJUSTMENTS