Datel DMS-PS-CM - Manual (Page 2)

Technical enquiries email: [email protected], tel: +1 508 339 3000
www.murata-ps.com
Performance/Functional Specifications
Typical at T
A
= +25°C and V IN = 85-264V @47-63Hz
➀ All models will also operate from a regulated and filtered 110 to 340Vdc input.
➁ Unless otherwise specified, load regulation is measured with the output under
test undergoing a load change of 100% to 50% at nominal line input and,
when applicable, with all other outputs operating at 50% of rated load.
➂ Transient response is defined as the output returning to within its specified
tolerance in 10ms or less, following a 90% load change.
AC Input
Input Voltage Range, All models ➀ 85-264V @47-63Hz
Input Current (115V/230V, typ.):
5-Watt Models 0.15A/0.07A
10-Watt Models 0.3A/0.13A
16-Watt Models 0.33A/0.16A
Inrush Current (All models, typical peak):
@115Vac 14.1A
@230Vac 32.5A
Isolation (Min.):
Output V1 to AC Input 3000Vac
Outputs V2 & V3 to AC Input 3000Vac + 1000Vdc
AC Input to Frame Ground 1500Vac
Output V1 to Frame Ground 500Vac
Outputs V2 & V3 to Frame Ground 500Vac + 1000Vdc
Outputs V2 & V3 to Output V1 1000Vdc
Output V2 to Output V3 2000Vdc
Frame Ground Leakage Current (Max.):
@115Vac 0.5mA
@230Vac 3.5mA
Switching Frequency (Typical):
V1 (5W and 10W models) 75kHz
V1 (16W models) 83kHz
V2 & V3 (All models) 100kHz
Line Fuse (Built-in) 1A/250Vac, 5 x 20mm, meeting
IEC60127-2, sheet 3 specification for time lag fuses
(slow-blow)
AC Mains Terminal Block (TB4):
Wire Size & Type 14-20AWG (2.5 to 0.5mm 2 ),
solid or stranded
Insulation Strip Length 0.25 inches (6.4mm)
Screw Tightening Torque 4.4 pound-inches (0.5Nm)
Rated Voltage 630V (VDE 0110-V. Group 2);
250V (VDE 0110-V. Group 3)
EMI (All models) Meets CISPR Pub. 22 & FCC
Class B
Safety Approvals Pending
DC Outputs
Line Regulation (All outputs) ±0.1% (max)
Load Regulation: ➁
V1 (All models) ±2%
V2 & V3 (All models) ±0.2% (max)
Output Accuracy (Max.):
V1 (All models) ±2.0%
V2 & V3 (All models) ±2.5%
Hold-Up Time (47-63Hz):
@115Vac 20mSec. typ.
@230Vac 80mSec. typ.
Noise & Ripple
(All models, 20MHz bandwidth):
See Noise & Ripple graphs
V1 40mVp-pk (typ.)
V2 & V3 8mVp-pk (typ.)
Transient Response ➂ See Transient Response graphs
DC Outputs (continued)
Efficiency (Typ.@ 120Vac, full load):
Single Output Models 75%
Dual Output Models 73%
Triple Output Models 71%
DC-Output Terminal Blocks (TB1, TB2, TB3):
Wire Size &Type 16-20AWG (1.5 to 0.5mm 2 ),
solid or stranded
Insulation Strip Length 0.25 inches (6.4mm)
Screw Tightening Torque 3.6 pound-inches (0.4Nm)
Short Circuit Protection (All outputs) Foldback, self-recovering
Overvoltage Protection V1 (max.) 134% x Vout
Environmental
Operating Temperature 0 to +50°C @ full rated power;
–25 to +70°C @ 50% rated power (see Figure 3)
Storage Temperature –40 to +85°C
Cooling Free air convection with derating
(see Figure 3 and Technical
Notes)
Humidity (Non-condensing) 0 to 85%
Physical
Dimensions See Mechanical Specifications
Weight:
5 Watt Models 5.8 ounces (165 grams)
10 Watt Models 6.9 ounces (195 grams)
16 Watt Models 7.9 ounces (223 grams)
Case Materials:
Outer Case ABS, UL94 5VA
DC/DC Modules Phenolic, UL94 V-0
AC/DC Modules Plastic, UL94 V-1
DMS-PS-CM Series
High Efficiency, AC/DC Instrumentation Power
Supplies with Individually Isolated Outputs
MPM_DMS-PS-CM_B01 Page 2 of 8