Lumens Technology DC192 Firmware Upgrade Instruction User Manual
Dc192- firmware(fw) upgrade instruction
This manual is related to the following products:
Table of contents
Document Outline
- DC192- Firmware(FW) Upgrade Instruction
- Before FW upgrade, please check the current FW version of DC192.
- ([Menu]( [Setting]( [Advanced]([Firmware Version])
- If the current FW before DGA103(included), please upgrade to FW DGA104B first.
- Please refer to “ 2. Upgrade to the FW DGA104B.”
- After upgrade to FW DGA104B, please upgrade to the latest version.
- Please refer to “3. Upgrade to the latest FW version.”
- If the current FW after DGA104B, please upgrade to the latest version directly
- Please refer to “3. Upgrade to the latest FW version.”
- Upgrade to the FW DGA104B
- *Note: upgrade to DGA104B may cause the files and custom logo saved in the internal memory be erased. Please save the files before upgrade if necessary.
- Save the FW file ”DGA104B.BRN” & “FW_DGA.BRN” into a USB flash drive.
- Please put the “unzipped” file into USB flash drive.
- Put the FW files in the Root directory, not subdirectory.
- If two more firmware files coexist in the USB flash drive, the unit will always detect the latest version.
- Plug in the power cord and connect the unit with a monitor/projector
- Insert the USB flash drive into the USB port
- Power on the unit and access the service menu
- Please use Keypad to call the “Service Menu”.
- Press “Enter”(do not release), then press” Zoom+”, hold both buttons in a second, then the “Service menu” will be shown on screen as following picture.
- Go [ISP] menu, select [Firmware Upgrade] and press [Enter]
- FW start upgrading.(around 30sec taken)
- *Note: Please do not stop the upgrade process which may cause the unit shut down.
- Power reset the unit when the process finish.
- (Unplug and re-plug the power cord to take effect.)
- After re-plug the power cord, the unit will power on automatically and continue the FW upgrade. (around 1min taken)
- *Note: Please do not stop the upgrade process which may cause the unit shut down.
- Restart the unit after upgrading successfully.
- (Unplug and re-plug the power cord to take effect.)
- Check FW version (DGA104B) on OSD.
- ([Menu]( [Setting]( [Advanced]([Firmware Version])
- Finished
- Upgrade to the latest FW version
- Save the FW file ”DGAXXX.BRN” into a USB flash drive.
- Please put the “unzipped” file into USB flash drive.
- Put the FW files in the Root directory, not subdirectory.
- If two more firmware files coexist in the USB flash drive, the unit will always detect the latest version.
- Plug in the power cord and connect the unit with a monitor/projector.
- Insert the USB flash drive into the USB port.
- Power on the unit and access the service menu
- Go [ISP] menu, select [Firmware Upgrade] and press [Enter].
- FW start upgrading.(around 2mins taken)
- *Note: Please do not stop the upgrading process which may cause the unit shut down.
- Restart the unit after upgrading successfully.
- (Unplug and re-plug the power cord to take effect.)
- Check FW version on OSD.
- ([Menu]( [Setting]( [Advanced]([Firmware Version])