Dolphin Peripherals DX5B User Manual
Page 6
DX 5 BATTERY
Joystick
EXIT/BACK
ENTER/SEND/SET
Screen
Battery cover
Menu
selection
ENTER/
SEND
EXIT/
BACK
5
ENTER/
SEND
EXIT/
BACK
5 ) R e m o t e C o n t r o l U n i t ( R . C . U . )
These buttons are used for switching between menus and options.
This button is used to switch on the R.C.U., to select a required menu, to send or to set a
parameter or a program.
This button is used to exit from a menu or move back a step.
This button is also used to turn off the R.C.U. Press Exit a number of times until R.C.U. turns off.
If a parameter was modified, then just before final exit you may be required to send your new set of Parameters.
5.1) Description and Use of Menus
5.1.1) Cleaning Programs
• REGULAR – Floor and walls cleaning program.
• ULTRAclean – Slower movement for special thorough cleaning.
Note: ULTRAclean mode can only be selected from REGULAR mode.
• WATERline – For special attention to walls and water line.
Note: For efficient WATERline cleaning program, position the handle diagonally exactly as shown in Fig B.
If you choose WATERline or ULTRAclean modes, the cycle time parameter will be automatically set to
1 hour (one). these parameters will not remain in the DOLPHIN memory for the next cycle. Instead, the DOLPHIN
automatically switches to REGULAR mode.
• LAPpool – Suitable for this specific type of pool – narrow and long.
Note: If you choose a LAPpool cleaning mode, set the pool length parameter after setting this mode.
5.1.2) Parameters
• CLIMB-EVERY – This option controls the frequency of wall climbing e.g.: at which frequency the DOLPHIN
should climb on the walls.
• CYCLE-TIME – Choose the most suitable cycle time.
• POOL-LENGTH – Program the pool length.
5.2) R.C.U. Battery Replacement
If the message "Low Battery" appears on the R.C.U. screen:
• Open the battery cover.
• Remove all used batteries from the R.C.U.
• Place two 1.5 V AAA batteries into the R.C.U. as shown in the drawing inside the battery housing.
• Close the battery cover.
If you are not using your Remote Control Unit for more than 6 months – remove batteries.