Danby DWM99W - Manual (Page 9)

8
• Connect fill hose (with 90 0 elbow) to either the
HOT/COLD water inlet valve located at the back
of the washing machine, tighten moderately.
(remember to install the “cap/plug” on the inlet
valve not being used)
• Connect the opposite end of the hose directly to
the body of the quick connect. Fig. F
• Attach the quick connect directly to the faucet
adapter, by pulling the outer collar (ring)
downward while pushing the quick connect
upward onto the faucet. Release the outer collar
(ring) and the quick connect will lock into place.
Fig. H
• Slowly open the water supply line and check for
any sign of leaks at all water connection points.
• If leaks occur, immediately close the water supply
and effect the necessary repairs and/or replace
ment of any/all defective connections. If you are
unable to effect suitable repairs yourself, call our
toll free CUSTOMER HELP LINE at
"1 800 26 DANBY and ask for assistance.
NOTE: Once the water supply line to the machine
is open, the inlet hose is pressurized. (even when
the water supply is closed immediately thereafter)
NOTE: Failure to relieve (release) hose pressure
before attempting to disconnect the hose from the
faucet can result in back pressure over-spray.
WARNING: Incoming water temperature can be
very hot and back pressure over-spray can cause
severe burns and/or scalding.
NOTE: To relieve (release) hose pressure, close
the water faucet. Press and "Hold" the "red"
(pressure relief) button located on the front (body)
of the quick connect until the flow of water stops.
Fig. F
When the flow of water has stopped, the hose
pressure is released and it is now safe to
disconnect the hose from the faucet adapter.
Permanent Hose Installation
(dual hose)
If your washing machine is to be permanently
installed both fill hoses are required. The following
accessories are not required for permanent
installation applications;
• Water Inlet Hose Quick Connect.
• Faucet Adapter.
• Water Inlet Valve Cap/Plug.
We recommend that you store these items in a safe
place for future use, in the event there is ever a
need to change your installation method.
Connecting the Water Inlet Hoses:
• Install a rubber washer into each end of both fill
hoses.
• Connect the both fill hoses (with the 90º elbow)
respectively to both the HOT & COLD water
valves located at the back of the washing machine
and tighten moderately. Fig. G
Rubber Ring
Connecting
Nut
F
Water
Inlet Hose
Outer
Collar
Pressure
Relief Button
Cold Water
Connection
Hot Water
Connection
Water Mixing
Valve
Water Inlet
Hoses
Water Supply
Faucets
G
H
Outer
Collar