Dual MXDM70 - Manual (Page 2)

2
MXDM70 INSTALLATION
Preparation
TYPICAL FRONT-LOAD DIN MOUNTING METHOD
Please read entire manual before installation.
Before You Start
• Disconnect negative battery terminal. (consult a qualified technician for instructions)
• Avoid installing the unit where it would be subject to high temperatures, such as from
direct sunlight, or where it would be subject to dust, dirt or excessive vibration.
Getting Started
• Remove 2 transit screws located on top
of the unit. Cover transit screw holes
using the supplied adhesive dot labels.
• Insert the supplied keys into the slots
as shown, and slide the unit out of the
mounting sleeve.
• Install mounting sleeve into
opening, bending tabs to secure.
• Connect wiring harness and
antenna. (consult a qualified
technician if you are unsure)
• Test for correct operation and
slide into mounting sleeve to secure.
• Snap trim ring into place.
• Mount the iplug™ adapter to any
smooth clean surface using the supplied
double-sided tape or #2 x 3/8” Phillips
head screws.
MWR30 Wired Remote
(sold seperately)