Back panel / control elements, Francais, Francais deutsch english 7 – LD Systems STINGER 15 HP User Manual

Page 7

BACK PANEL / CONTROL ELEMENTS:

INPUT
Both 4-pole Speakon sockets are parallel wired and can be used for both operating modes, Fullrange and
Biamping mode.
If one socket is used as Input, the other socket can be used as Link Output.

For Fullrange mode (operating mode switch

in position FULLRANGE) only pin 1+ and 1- of the SPEAKON

sockets are used. Frequency separation for high and low frequencies will be done by the internal passive
crossover.

For Biamping mode (operating mode switch in

position BIAMPING) pin 1+ and 1- of the Speakon sockets

are used for low frequencies (woofer) and pin 2+ and 2- are used for high frequencies (tweeter). Frequency
separation has to be done by an active crossover (LDDS21 or LDDPA260) before amplification (recommended
crossover frequency 1000Hz).

OPERATING MODE SWITCH
For Fullrange mode set to FULLRANGE.
For Biamping mode set to BIAMPING.

FRANCAIS

DEUTSCH

ENGLISH

This manual is related to the following products:

LDEB 15HP