Danby DCAP 12030 - Manual (Page 40)

20
Care and Maintenance
1) Do Not use gasoline, benzene, thinner or any
other chemicals to clean this unit ,as these
substances may cause damage to the finish and
deformation of plastic parts.
2) Never attempt to clean the unit by pouring water
directly over any of the surface areas, as this will
cause deterioration of electrical components and
wiring insulation.
Removal and Cleaning of the Air Filter
If the air filter becomes clogged with dust/dirt, air
flow is restricted and reduces cooling efficiency. The
air filter should be cleaned every two (2) weeks.
More frequent cleaning may be necessary
depending upon indoor air quality. NOTE: The air
filter is located at the (upper) rear side of the unit.
1) To remove the air filter: Pull the air filter upward
in the direction of the arrow.
2) Dust/Dirt clogged in the filter can be removed by
vacuum cleaning the soiled areas.
4) The filter can also be washed in lukewarm soapy
water while rubbing it lightly with a brush. A mild
detergent (dishwashing soap) is recommended.
5) Rinse the filter well using clean water. Allow time
to dry before reinstalling into the unit.
6) Replace the air filter.
7) Replacement air filters are available through the
Customer Service Parts Department.
CAUTION
Never operate the unit without the air filter in place
as this may result in damage to the unit.
CAUTION
Before cleaning or servicing this unit, it is
recommended that the unit be disconnected from
any electrical supply outlet.
Air Filter
Tab
Fig. 34