Control elements – LD Systems LAX 12 D USB User Manual

Page 9

PAN/BAL

The mono channels of the LAX12D have panorama (PAN) controls and the stereo channels have balance
(BAL) controls, both of which are used to distribute the signal to the right and left output channels.

MUTE/ALT3-4

Each of the channels of the LAX12D has a MUTE/ALT3-4 switch. This switch can be used to send the signal
of the respective channel to the ALT3-4 output.

SOLO

The SOLO switch lets you hear only the signal of the channel for which the solo function is activated (button
pressed) without the other channels. The SOLO switch is especially useful for adjusting input levels (gain
adjustment) and as a "preview" option for monitoring the respective signal.

PEAK LED

All channels of the LAX12D are equipped with a peak LED for monitoring the respective audio signal. If the
peak LED lights up (6 dB below the actual clipping threshold), this means that the signal is peaking and
distortion may ensue.

CHANNEL FADER

This fader controls the overall volume of the respective channel, i.e., the level at which the signal is sent to
the main mix.

2-TRACK IN/OUT

TAPE IN: Use the TAPE IN input to connect a tape recorder or DAT recorder. Press the 2TK IN button on the
front panel to send the signal coming from the connected device to the PHONES/CONTROL ROOM output or
the 2TK TO MAIN MIX button to send it to the MAIN MIX output. TAPE OUT: The mix can be output to a tape
recorder via these cinch (RCA) connectors.

2TK IN CONTROL: This control is used to adjust the level of the

2TK IN signal, which can be varied from ∞ to MAX.

CONTROL ELEMENTS:

ALIANO

POLSKI

ESP
AÑOL

FRANCAIS

DEUTSCH

ENGLISH