Lacava 1832 - Manual (Page 4)

LACAVA LLC 4
Installation Instructions/Instrucciones de Instalación
SPOUT HAND
SHOWER
HOT
COLD
1. Map out and prepare the mounting holes to the correct diameter for each component.
2. Install each Hot and Cold valve (A) and handle (B) by placing the valve with the washers (C) and lock-nut (D)
up through the mounting hole from under the mounting surface. Then slide the handle over the cartridge stem (E)
and thread onto the valve.
3. Thread the lock-nut up by hand until snug. Lastly use the 2 philips screws in the lock-nut and turn until tight (DO
NOT DAMAGE MOUNTING SURFACE BY OVERTIGHTENING).
4. Install the diverter assembly in the same manner as the Hot and Cold assemblies.
5. Place the spout through the mounting hole from above the mounting surface and secure using the washers,
lock-nut, and phillip screws from underneath.
6. Place the hand-shower holder in the mounting hole and secure from underneath using the lock-nut and phillip
screws.
7. Run the 59” flexible hand shower hose through the holder and thread into the diverter valve. Then thread the
hand shower onto to hose.
8. Install the flexible water lines between the controls and spout.
9. Install your Hot and Cold supply lines. Turn supply water on, open valves, and inspect for any leaking in the
system.
A
B
C
D
E
COLD
SUPPLY
HOT
SUPPLY