Lacava 1584 - Manual (Page 5)

LACAVA LLC 5
10. Place the escutcheon over the spout from behind.
11. Wrap the threaded spout connection with Teflon tape
and then tighten the spout into the rough-in.
12. Push the escucheon back until it is flush with the wall.
13. Place an escutcheon over each handle base, making
sure the black rubber o-rings are in their designated
place on the back of both esctucheons.
14. Tighten a handle onto each cartridge extension. Before
the handle bases are completely tight, the handles can
be adjusted so that they are orientated in the desired
position.
15. Push both handle escutcheons back until they are flush
with the wall.
16. If desired, place a small bead of silicone around outside
edge of each escutcheon.
17. Turn on the water supply and check for any leaks.