Lacava 1420 - Manual (Page 4)

LACAVA LLC 4
Installation Instructions/Instrucciones de Instalación
1. Remove the locking nut and rubber washer from the
mounting post.
2. Place mixer body with its escutcheon ring and o-ring
still attached through the faucet hole of the mounting
surface.
3. From below the mounting surface, slide the rubber
pad and metal mounting support onto the mounting
post so that it presses up against the mounting surface.
4. Screw the locking nut onto the mounting post by hand
until tight, and then turn an additional ¼ turn using a
wrench. Be careful not to over tighten the bolt, as this
may cause damage to the mounting surface.