Lacava 012404SP - Manual (Page 5)

LACAVA LLC 5
10. Slide the small escutcheon over the spout.
11. Wrap the threaded end of the spout with Teflon tape
and then tighten the spout into the brass rough in until
tight.
13. Place an escutcheon over the back of each control
handle, making sure the o-ring sits in between the
escutcheon and finished wall.
14. Press a handle onto each cartridge and then spin the
handle base until tight. The escutcheons should be
flat against the finished wall.
15. If desired, place a small bead of silicone around outside
edge of each escutcheon.
16. Turn on the water supply and check for any leaks.