Lacava llc 5 – Lacava 0114 User Manual
Page 5

LACAVA LLC
5
10. Place the backplate over the rough-in assembly and
screw the spout into place until tight. Wrap the threaded
end of the spout with teflon tape prior to installation.
11. Slide the handle onto the cartridge stem and then using
the provided Allen wrench, tighten the set screw to keep
in place.
12. Push the cap cover into its designated hole over
the set screw.
13. If desired, place a small bead of silicone around outside
edge of the backplate.
14. Turn on the water supply and check for any leaks.
8. Finish the surrounding wall. Use the plaster guards as a
guide for the correct diameter of the holes.
9. Remove plaster guards once the finished wall is complete.