Lacava 0114SP - Manual (Page 5)

LACAVA LLC 5
10. Slide the small escutcheon around the spout and wrap
the threaded end of the spout with teflon tape. Then
thread the spout into place by hand until tight.
11. Slide the large escutcheon into place over the cartridge
housing until flush against the wall.
12. Press the handle onto the cartridge stem and then using
the provided Allen wrench, tighten the set screw.
13. Push the cap cover into the set screw hole.
14. If desired, place a small bead of silicone around outside
edge of each escutcheon.
15. Turn on the water supply and check for any leaks.
8. Finish the surrounding wall. Use the plaster guards as a
guide for the CORRECT diameter of the holes.
9. Remove plaster guards once the finished wall is complete.