Lacava 2812 - Manual (Page 5)

LACAVA LLC 5
4. Place the spout through its faucet hole and from below
the mounting surface, slide the rubber pad and metal
mounting support onto the mounting post.
5. Screw the locking nut onto the mounting screw by hand
until tight, then turn an additional ¼ turn using a wrench.
Be careful not to overtighten the nut, as this may cause
damage to the mounting surface.
6. Place the handle through its faucet hole and from below
the mounting surface, slide the rubber pad and metal
mounting support onto the threaded base.
7. Screw the locking nut onto the handle base by hand
until tight. If the nut does not fit all the way up to the
mounting surface then tighten the two screws until the
handle is secure. Be careful not to overtighten the nut,
as this may cause damage to the mounting surface.
8. Attach the vertical pop-up control rod to the connector
by sliding it through its designated hole and tightening
the screw to keep it in place.
9. Remove the gray plastic cap from the drain body and
then place the horizontal control rod into the opening so
that the plastic ball and gasket fit inside. Then slide the
plastic cap over the rod and tighten back into place.
10. Attach the horizontal control rod to the appropriate
height on the connector.
11. Connect a water line from the handle to the spout.
12. Connect both water supply lines from the handle to the
hot & cold water supply.