Lacava 13010 - Manual (Page 4)

LACAVA LLC 4
Installation Instructions/Instrucciones de Instalación
1. Prepare the holes in the mounting surface (Refer to
illustration for correct sizing).
2. Remove the locking nut, metal washer, and metal
spacer from the base of both the faucet and the con-
trol.
3. Place the faucet with its escutcheon into the faucet
hole in the mounting surface.
4. From below the mounting surface slide the metal
spacer then metal washer onto the base of the spout.
Then thread on the locknut and tighten to the mounting
surface (DO NOT OVERTIGHTEN: This can cause damage
to the mounting surface)
5. Repeat step 4 with the control handle.
6. Connect one supply line from the facuet to the
control.
7. Connect the other two supply lines to the control
handle.
8. Unscrew the top portion of the drain from the bottom.
9. Place the top portion into the drain hole and thread
the bottom portion onto the top from underneath the
sink.
θ 1 3/8” θ 1 1/4”
FAUCET
MIXER