Lacava 4288 - Manual (Page 6)

LACAVA LLC 6
ADJUSTMENT SCREW
Installation Instructions/Instrucciones de Instalación
9. Set length of pins on flush buttons in the tank
lid. Adjust so that buttons initiate flush when
pressed.
a. Loosen lock nut and adjust length of pins by
threading in or out.
b. Once desired length is attained tighten lock
nuts.
10. Replace cover on tank.
5. Slide primer onto the end of the tube on the flush valve
housing and connect hose from “bottom-in” valve to
primer.
6. Hook up incoming water line and let tank fill. Make sure
tank fills to fill line on tank and stops (adjust fill valve as
needed).
Now flush toilet. When refill stops note the height of the
water in the bowl.
7. Set height of primer. Use adjustment screw for larger
adjustments and sliding door for smaller adjustments.
Height of primer dictates amount of water diverted to the
toliet bowl. (Note: water in bowl should fill to slightly
below when water begins to drain down waste hole)
8. Continue adjustments and test flush until desired
amount of water in bowl is reached.
LOCKNUT
SLIDING DOOR