La Crosse Technology TX22U User Manual
Page 2
2
1)
Remove the mounting bracket from the Thermo-hygro
transmitter .
2)
Place the mounting bracket over the desired location. Humidity
cap must be in the upright position.
3)
Through the two screw holes of the bracket, mark the mounting
surface with a pencil.
4)
Screw mounting bracket onto the mounting surface. Ensure
that the screws are tight against the bracket.
5)
Insert the Thermo-hygro transmitter into the bracket.
MOUNTING WITH ADHESIVE TAPE
Two-sided tape is included only as a positioning tool while you test for
signal reception and properly position your sensor. Tape only should
not be used for mounting as the sensor may fall. Please secure with
screws or nylon straps.
MOUNTING WITH NYLON STRAPS
1)
Remove the mounting bracket from the Thermo-hygro
transmitter.
2)
Place two nylon straps through the slots on the mounting
bracket.
3)
Place the Thermo-hygro transmitter in your desired mounting
location.
4)
Fasten the two nylon straps securely around the mounting
location.
MAINTENANCE AND CARE
• Extreme temperatures, vibration, and shock should be avoided to
prevent damage to the units.
• Clean displays and units with a soft, damp cloth. Do not use
solvents or scouring agents; they may mark the displays and
casings.
• Do not submerge in water.
• Immediately remove all low powered batteries to avoid leakage and
damage.
• Opening the casings invalidates the warranty. Do not try to repair
the unit. Contact La Crosse Technology for repairs.
SPECIFICATIONS
Note:
Detailed Set up procedures of the
Weather Station, the Relay Transmitter, the Rain sensor and the Wind
Sensor refer to the main operation manual of WS-1610.
Weather data measuring range:
Outdoor and dew
point:
-40
°F to +140°F with 0.2°F resolution (-
40
°C to 59.9°C with 0.1°C resolution)
“OFL” displayed if outside this range
Outdoor relative
humidity measuring
range:
1% to 99% with 1% resolution (“- - “
displayed if < 1%; "99" displayed if
≥99%)
Transmission range:
330 feet (in open space)
Power Supply:
Thermo-hygro
transmitter :
2 x AA, IEC LR6, 1.5V
Battery life cycle:
Approximately 12 months
Recommended
battery type:
Alkaline
Dimensions (H x W x D):
Thermo-hygro
transmitter
2.25" x 2.44" x 6.18"
(57.3 x 62 x 157 mm)
WARRANTY INFORMATION
La Crosse Technology, Ltd provides a 1-year limited warranty on this
product against manufacturing defects in materials and workmanship.
This limited warranty begins on the original date of purchase, is valid
only on products purchased and used in North America and only to
the original purchaser of this product. To receive warranty service,
the purchaser must contact La Crosse Technology, Ltd for problem
determination and service procedures. Warranty service can only be
performed by a La Crosse Technology, Ltd authorized service center.
The original dated bill of sale must be presented upon request as
proof of purchase to La Crosse Technology, Ltd or La Crosse
Technology, Ltd’s authorized service center.
La Crosse Technology, Ltd will repair or replace this product, at our
option and at no charge as stipulated herein, with new or
reconditioned parts or products if found to be defective during the
limited warranty period specified above. All replaced parts and
products become the property of La Crosse Technology, Ltd and must
be returned to La Crosse Technology, Ltd. Replacement parts and
products assume the remaining original warranty, or ninety (90) days,
whichever is longer. La Crosse Technology, Ltd will pay all expenses
for labor and materials for all repairs covered by this warranty. If
necessary repairs are not covered by this warranty, or if a product is
examined which is not in need or repair, you will be charged for the
repairs or examination. The owner must pay any shipping charges
incurred in getting your La Crosse Technology, Ltd product to a La
Crosse Technology, Ltd authorized service center. La Crosse
Technology, Ltd will pay ground return shipping charges to the owner
of the product to a USA address only.
Your La Crosse Technology, Ltd warranty covers all defects in
material and workmanship with the following specified exceptions: (1)
damage caused by accident, unreasonable use or neglect (including
the lack of reasonable and necessary maintenance); (2) damage
occurring during shipment (claims must be presented to the carrier);
(3) damage to, or deterioration of, any accessory or decorative
surface; (4) damage resulting from failure to follow instructions
contained in your owner’s manual; (5) damage resulting from the
performance of repairs or alterations by someone other than an
authorized La Crosse Technology, Ltd authorized service center; (6)
units used for other than home use (7) applications and uses that this
product was not intended or (8) the products inability to receive a
signal due to any source of interference.. This warranty covers only
actual defects within the product itself, and does not cover the cost of
installation or removal from a fixed installation, normal set-up or
adjustments, claims based on misrepresentation by the seller or
performance variations resulting from installation-related
circumstances.
LA CROSSE TECHNOLOGY, LTD WILL NOT ASSUME LIABILITY
FOR INCIDENTAL, CONSEQUENTIAL, PUNITIVE, OR OTHER
SIMILAR DAMAGES ASSOCIATED WITH THE OPERATION OR
MALFUNCTION OF THIS PRODUCT. THIS PRODUCT IS NOT TO
BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC
INFORMATION. THIS PRODUCT IS NOT A TOY. KEEP OUT OF
CHILDREN’S REACH.
This warranty gives you specific legal rights. You may also have other
rights specific to your State. Some States do no allow the exclusion of
consequential or incidental damages therefore the above exclusion of
limitation may not apply to you.
For warranty work, technical support, or information contact:
La Crosse Technology
2809 Losey Blvd. S.
La Crosse, WI 54601
Phone: 608.782.1610
Fax: 608.796.1020
e-mail:
(warranty work)
(information on other products)
web:
www.lacrossetechnology.com
All rights reserved. This handbook must not be reproduced in any
form, even in excerpts, or duplicated or processed using electronic,
mechanical or chemical procedures without written permission of the
publisher.
This handbook may contain mistakes and printing errors. The
information in this handbook is regularly checked and corrections
made in the next issue. We accept no liability for technical mistakes
or printing errors, or their consequences.
All trademarks and patents are acknowledged.