Dixon 1998 - Manual (Page 11)

SPECIFICATIONS
Models ZTR 4515Band4515K
CHASSIS: Twin 12 gauge side frames and 7 gauge transmission and engine base plate.
BODY: All body parts are made of high density polyethylene. Dent and corrosion
resistant. Front body contains access panel for battery service.
MOWER DECKS: 36" Deck: 1 1 GA Laser Cut Fabricated - 36" Cut Width 42"
Deck: 13 GA Stamped Steel Construction - 42" Cut Width
Cut height approximately 1 " to 4" via 7 position lift handle.
BLADE DRIVE: Electric clutch.
TRANSMISSION: Each rear wheel is independently driven by a HydroGear IZT hydrostatic drive.
ENGINE:
Model 451 5B: 15 HP Vanguard Briggs & Stratton, 4-Cycle, Single Cylinder, Overhead
Valve, Air-Cooled, Gasoline, Vertical Shaft With Cast Iron Cylinder
Sleeve, Oil Pump With Integral Oil Filter.
Model 451 5K: 15 HP Kohler Command 15, 4-Cycle, Single Cylinder, Overhead Valve,
Air-Cooled, Gasoline, Pressure Lubricated, With Oil Filter, Vertical Shaft,
Aluminum Head and Block with Cast-Iron Cylinder Liner.
STARTING SYSTEM: Electric by key switch operation with safety interlock blade drive.
TIRES: Front 1 1 X 4.00 X 5 ribbed tread.
Rear 1 8 X 8.50 X 8 Multi-Trac
RECOMMENDED
TIRE PRESSURE:
Front 16-21 Ibs.
Rear 8-1 4 Ibs.
CAPACITIES: Fuel 2.7 gallons total. Engine Briggs
& Stratton - 1 .50 quarts oil. Kohler - 2 quarts
oil with filter.
DIMENSIONS: Width 44" Maximum Track Width
Height 42" to top edge of seat. Length
72" hitch tab to front bumper. Weight
Power Unit: 463 Ibs. w/36" Deck:
544 Ibs. w/42" Deck: 541 Ibs.
NOTE: Additional information provided in service instructions under the individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
Page 8