Dorel Juvenile Group 4358-3832A - Manual (Page 19)

Locking Clip
NOTE: The locking clip is located on the bottom of the
seat.You do not need a locking clip when using this seat as
a belt-positioning booster.
Remove the locking clip when the vehicle seat belt is not
being used with the child restraint. A locking clip will not
fix all types of seat belt problems.
Before you put your child restraint in the vehicle, buckle the
lap/shoulder belt. Pull on the lap belt portion. If it loosens or
slips, you must either use a locking clip to hold the seat belt
tight or move the child restraint to another seating location.
Grasp both vehicle belts
together just behind the
buckle plate and unbuckle.
NOTE: If the buckle plate
ends up behind the child
restraint, grasp the belts to
the outside of the child
restraint, as close to the
buckle plate as possible.
1
Thread both vehicle lap
and shoulder belts through
the slot (as shown) and
out other side. Buckle.
Pull up on shoulder belt
until all slack is out and lap
belt is tight.
2
3
Thread both portions of
the vehicle belt onto the
locking clip.
4
Position locking clip about
1 in. (2.5 cm) from vehicle
belt’s buckle plate.
5
Rebuckle belt. Lap belt
portion should now be
tight. If not, remove
locking clip and repeat all
steps.
35 34
4358-3832A US Prospect 2/23/06 10:18 AM Page 37