Kiddy City'n move - Manual (Page 17)

EN
17
6.2 Removing and mounting the cover
Remove the sunroof like like described in section 3.3.
Remove the belt system like described in section 6.1.
To remove the seat cover open 6 snap fasteners at the side of the seat and backrest
(fig. 24 no. 1–6). Open the snap fasteners on the second side also.
Now pull off the cover from the upper part of the backrest (fig. 25) and from the foot
rest.
Now pull off the cover from the upper part of the backrest and from the foot rest.
To mount the cover follow the steps for removing in reverse order!
WARNING
Don’t forget to mount the belt system (see section 6.1)
7. Care and maintenance
7.1 Care and maintenance of the chassis
Periodically check the chassis for loose screws, rivets or worn out or defective parts.
Check the fabric cover and belts for open seams or other defects.
Don’t use the stroller when you noticed a defect. Defective parts have to be changed
or repaired before using the stroller again.
If a wheel is squeaking, spray some liquid silicone lubricant on the axles.
Wipe off unnecessary lubricant.
The chassis can be cleaned with a mild cleanser or with a damp cloth. Never use
caustic cleansing agents (e.g. solvents, strong detergents).
7.2 Fabric care in general
‚All of our fabric meets the highest standards regarding colourfastness against UV
radiation. Nevertheless, all fabric fades when exposed to UV radiation. This is not due
to defective fabric but to normal wear and tear, which is not covered by the warranty.
EN