Sirio Tornado 27 - Manual (Page 2)

MOUNTING INSTRUCTIONS MOUNTING INSTRUCTIONS
1 1 2 2
3 3
HI-QUALITY ANTENNAS MADE IN ITALY
Insert the PVC cap (8) on
the aluminium tube (5)
then insert the tubes in the
bottom section (9) and
lock they using the screws
(6) and 2mm hexagonal
key (7).
Mast Æ 35-42mm (not supplied)
Parts List
Pos Q.ty Description
1 1 5 sections telescopic aluminium whip
2 5 plastic jointing sleeves (5 different sizes)
3 10 Æ 3.9x12.7 phillips tapping screws
4 5 M4 washers
5 5 Æ 6x8x1170mm aluminium tubes
6 5 M4x4 hexagon socket set screws cup point
7 1 2mm hexagonal key
8 5 PVC cap for Æ 8 mm aluminium tubes
9 1 bottom section assembled with coil and connector
10 4 M6 hexagonal nuts
11 4 M6 spring lock washers
12 4 M6 washers
13 2 steel V brackets
14 2 steel plane brackets
15 2 M6x240 mm U-bolt
n. 1 tape rules (meter)
n. 1 phillips screwdriver
n. 1 10 mm open key
Mounting needed tools:
B
Copyright SIRIO antenne - Technical Data are subjected to change - Printed in ITALY - Rev. 16/10/2008 - Cod. ID039
L=1120mm
7
6
1
2
3
P u l l o u t t h e s e c t i o n s o f
telescopic aluminium whip (1),
insert the jointing sleeves on the
tubes (2) and lock they using the
screws (3) and washers (4).
Insert one of aluminium tube (5)
at L=1120mm and lock it using
the screw (6) and 2 mm
hexagonal key (7). Insert the
PVC cap (8).
NOTE: the L=1120 mm is just the
initial position. For fine-tuning
please use an SWR-meter
1
5
4
7
6
8
8
5
Mount the antenna on the mast
using parts (10) (11) (12) (13)
(14) and (15) in according to
the picture.
10
11
12
13
14
15
9