Yaesu VX-3R Сервис-мануал - Manual (Page 14)

14
Alignment
Low TX Power Adjustment
P Connect the 50-Ohm Dummy Load and Wattmeter to
the ANT jack.
P Rotate the DIAL knob one click clockwise to select the
alignment item "LP".
P Press the [V/M] key.
P Press the PTT switch, then rotate the DIAL knob so that
the Wattmeter reading is 0.1 W ±0.05 W.
P Press the [V/M] key again.
MAX Deviation Adjustment
P Connect the 50-Ohm Dummy Load, Wattmeter, and
Deviation Meter to the ANT jack.
P Connect the AF Generator to the MIC/SP jack, and then
set the output level to 50 mV at 1 kHz.
P Rotate the DIAL knob one click clockwise to select the
alignment item "dEV".
P Press the [V/M] key.
P Press the PTT switch, then rotate the DIAL knob so that
the Deviation meter reading is 4.2 kHz ±0.1 kHz.
P Press the [V/M] key again.
CTCSS Tone Deviation Adjustment
P Connect the 50-Ohm Dummy Load, Wattmeter, and
Deviation Meter to the ANT jack.
P Rotate the DIAL knob one click clockwise to select the
alignment item "100".
P Press the [V/M] key.
P Press the PTT switch, then rotate the DIAL knob so that
the Deviation meter reading is 0.65 kHz ±0.05 kHz.
P Press the [V/M] key again.
DCS Deviation Adjustment
P Connect the 50-Ohm Dummy Load, Wattmeter, and
Deviation Meter to the ANT jack.
P Rotate the DIAL knob one click clockwise to select the
alignment item "dCS".
P Press the [V/M] key.
P Press the PTT switch, then rotate the DIAL knob so that
the Deviation meter reading is 0.65 kHz ±0.05 kHz.
P Press the [V/M] key again.
This completes the internal alignment routine for all
bands. To save all settings and exit, press the [HM/RV]
button.