Kleenmaid KAW693 Version 35956R1 - Manual (Page 20)

19
Before You Call For Service . . .
(You may save time and money by checking the following):
Won't
Fill
Fills But
Won't Agitate
Won't
Spin
Possible Reason —
Do This To Correct
Be sure the power cord is plugged all the way into the
electrical outlet.
Close the loading door.
Check the house fuse or circuit breaker.
Has the motor overload protector cycled?
Turn on the hot and cold water faucets.
Pull timer knob out to start the washer.
Was the last spin completed?
Clean the filter screens located at the faucet end of the inlet
hoses. Owner is responsible for service call regarding
cleaning of the screens.
Water is siphoned from the washer during the cycle. Refer to
the INSTALLATION INSTRUCTIONS supplied with the
washer.
Are the controls properly set?
Broken drive belt. Call the serviceman.
If Your Washer:
If Service Is Required . . .
If service is required, contact the
nearest Authorized Kleenmaid
Service Centre.
If you are unable to locate an
authorised service centre or are
unsatisfied with the service
performed on your washer, write
to:
Kleenmaid
P.O. Box 5560
Maroochydore South QLD 4558
When calling or writing about your
washer, PLEASE GIVE THE
MODEL AND SERIAL
NUMBERS. The model and serial
numbers are located on the
nameplate. The nameplate will be
in the location shown. Please
include a copy of your invoice and
any service receipts you have.