Kleenmaid PSA22 - Manual (Page 16)

Place the compression nut and ferrule (sleeve) onto
the end of the tubing as shown.
Insert the end of the tubing into the water valve
connection as far as possible. While holding the
tubing, tighten the fitting.
Fasten the tubing into the clamp provided to hold it
in a vertical position. You may need to pry open the
clamp.
Remove the plastic flexible cap from the
water valve.
NOTES:
• Before making the connection to the refrigerator,
be sure the refrigerator power cord is not plugged
into the wall outlet.
• We recommend installing a water filter if your
water supply has sand or particles that could clog
the screen of the refrigerator’s water valve. Install
it in the water line near the refrigerator.
CONNECT THE TUBING TO THE
REFRIGERATOR 1
Remove the access cover.
Installation Instructions
INSTALLING THE WATER LINE
(CONT.)
Typical
Compression
Nut
Tubing
Clamp
Tubing
Ferrule
(sleeve)
Refrigerator
Connection
Reattach the access cover.
Set the icemaker power switch to the l position. The
icemaker will not begin to operate until it reaches its
operating temperature of -9°C or below. It will then
begin operation automatically if the icemaker power
switch is in the l position.
NOTE: In lower water pressure conditions, the
water valve may turn on up to 3 times to deliver
enough water to the icemaker.
START THE ICEMAKER 3
Power
switch
Arrange the coil of tubing so that it does not vibrate
against the back of the refrigerator or against the
wall. Push the refrigerator back to the wall.
TURN THE WATER ON AND PLUG
IN THE REFRIGERATOR 2
16