Kleenmaid RFS140 - Manual (Page 12)

12
Changing the Direction of Opening the Door
(models without the worktop)
If you find the direction of opening the door on your appliance inconvenient,
you can change it. Holes on the opposite side have already been prepared in
the factory and are now plugged.
•
Remove the cover of the upper hinge, unscrew the upper hinge and take
off the door of the appliance.
•
Unscrew the lower hinge with foot and washer.
•
Fix the lower hinge with foot and washer to the opposite side and fix the
other foot on the place where previously was the hinge.
•
Remove the fastener of the door corner with the hole and replace it to the
opposite side.
•
Put the door on the lower hinge.
•
Fix the upper hinge and cover it.
•
Unscrew the handle and replace it to the opposite side (not for handles
mounted horizontally).
Some screws are covered with caps. Take them off before undoing the
screws.
•
Plug the remaining holes with decorative caps.
•
Check the gasket, it shouldn't be creased and it should seal well.
Should the seal not adhere to the casing of the appliance perfectly, it will
have to be heated from a suitable distance (by means of hair drier, for
example) and lightly stretched to the required height.