Kleenmaid IC56 - Manual (Page 6)

6
Important
Ice maker can be installed one way only. Do not drill
additional holes.
24. Install two remaining 16 mm ( 5 /
8
") long sheet metal
screws to secure ice maker. Tighten all 3 screws
Using 6.35 mm (
1 /
4
") hex socket and driver.
25. Reinstall freezer shelf.
26. Position ice storage bucket on freezer shelf under ice
maker. Check for leaks at household water
connection and water valve. Correct any leaks.
Carefully tuck wires inside cover to avoid pinching
wires. Reinstall lower vertical cover on rear of
refrigerator cabinet by reversing procedure 4.
27. Create service loop (approximately 2.4 m or 8") using
extreme care to avoid kinks. Secure copper tubing
at back bottom horizontal cover using "P"-clamp,
provided.
Service
loop
"P" clamp
CAUTION !
To avoid property damage, all covers must be in place.
28. Plug in refrigerator and move refrigerator in place.
Level if necessary.
29. Check for water leaks 24 hours after installation.
21. Start 16 mm ( 5 /
8
") long sheet metal screw in top front
hole using 6.35 mm ( 1 /
4
") hex socket and driver. Leave
head out approximately 9.65 mm ( 3 /
8
").
Insert 16 mm ( 5 /
8
")
sheet metal screw
here
Water fill tube
with masking tape
removed
Electrical
connection
22. Hold ice maker in position. Verify two outside
electrical flats line up with flats in receptacle on
freezer back wall. Insert wire harness plug into
receptacle on rear wall until locking fingers on plug
snap into place. Slip ice maker hanger over sheet
metal screw.
• Locking fingers on plug must be positioned
vertically to mate with wire harness receptacle.
Wire harness
receptacle
Wire harness
plug
Sheet metal
screw
Ice maker
hanger
23. Ease ice maker water cup toward end of water fill
tube. Water fill tube fits under stainless steel clip.
Water fill tube must not be kinked. Water fill tube
elbow should extend approximately 9.65 mm (
3 /
8
")
into ice maker water cup and must be secured under
stainless steel clip.
Water fill tube Stainless
steel clip
Water
cup