Kleenmaid RHCBB90 User Manual
Page 9

9
The hood may be installed in the filtering or in the
ducting version.
Exhausting version (Fig.1) the hood aspirates
the kitchen air saturated with fumes and odours,
purifies it through the grease filters and expels
it through an outlet pipe. With his version the
charcoal filters are not required.
Filtering version (Fig.1A) the hood aspirates
the kitchen air saturated with fumes and odours,
purifies it through the grease filters and the
charcoal filters and returns clean air into the
room.
The charcoal filters are not supplied.
Decide from beginning on the type of
installation.
For greater efficiency, we recommend to
install the hood in exhausting version.
Use gloves during installation and
maintenance operations.
In case of exhausting version it is important :
- to prepare the hole and the duct of 150 mm.diameter
- to use a duct with the minimal indispensable length
- to use a duct with few curves as possible (max
curve angle 90°)
- to avoid to use flat ducts or with different sections
- to use a duct with the smoother surface inside and
of a certified material
- don’t connect the hood to fumes exhaust ducts
(fireplaces, boilers, stoves,…)
- the air can not be evacuated into a wall hole, if this
hole is not dedicated to this purpose
- to equip the room of air intakes in order to not create
air depression (it must not exceed the 0,04 mbar)
CONTROLS
A B C D E F G H I
A) ON/ OFF motor (it switches the hood on
the second speed)
B) 1st motor speed
C) 2nd motor speed
D) 3rd motor speed
E) 4th motor speed
F) ON/OFF lamps: if pressed long, it permits
to select 3 different levels. Last selected
level will remain in memory when the
cooker hood restarts.
G) TIMER: it permits to select 3 several
ranges(10’, 15’, 20’ minutes)
H) *Filter alarm
I) Remote control signal receiver
*Filter alarm:
the first operation once you have connected the
cooker hood to the power, is to set it into exhausting
or recycling mode. Proceed as follows:
once the cooker is connected all the keys will
light for some seconds: press the key on/off
for around 8 seconds until that the key H is not
lighted. Press the key B if you want that the
cooker hood works in exhausting mode (in this
way the charcoal filters counter is not working
because it is not required); the red key H is blinking
and you can confirm pressing it.
To set the cooker hood into recycling mode (grease
filters and charcoal filters counter) you must press
the key C after the 8 seconds and the key H will
be lighted red fix; pressing on it you can confirm.
After 30 hours working, the key H will light fix:
this means that it is time to clean the grease
filters. After 140 hours working the key H will blink
red: this means that the grease filters must be
cleaned and the charcoal filters replaced. To reset,
press the key H longer for second 7-8.
Note well: it is not possible to reset partially
the counter times until the system doesn’t show
one of the alarms. This means that intermediate
resets are not possible.