Kleenmaid RH24X to August 2008 - Manual (Page 6)

6
Closely follow the instructions set out
in this manual. All responsibility, for any
eventual inconveniences, damages or
fires caused by not complying with the
instructions in this manual, is declined.
Systems Available
Venting Outdoors
The rangehood has an upper air duct B
for external fumes exit.
Apply the flange C supplied.
Check that the filter/suction selector
(inside the rangehood) G is in the
suction (A) position.
Recirculating method - In the case
where it is not possible to discharge the
cooking fumes externally, the rangehood
may be used in the filter version by
fixing a carbon filter. The fumes and
vapours are recycled via the anterior grill
placed above the control panel. Check
that the filter/suction selector (inside
the rangehood) G is in the filter (F)
position.
Installation – Do not tile, grout or silicone
this appliance to the wall. Surface
mounting only. Do not fix chimney flue to
furniture or flyover shelves unless the
chimney flue can be easily removed in
case maintenance is ever required. The
rangehood must be placed at a minimum
distance of 650mm from either gas,
electric or combination cooktops. Please
check this measurement with your local
gas, electrical and building authority. The
rangehood maybe installed on the wall or
on the base of a cabinet; if supplied use
the hole gauge H to drill the correct
distance, or lean the cooker hood on the
wall or on the base of the cabinet and
mark the holes with a pencil.
Wall mounting – Insert the wall screw
anchors J in the drilled holes and the two
K screws in the upper drill holes. Remove
the grill and hook the rangehood to the 2
screws, finally from the inside, insert the
third screw L and lock them all in.
Cabinet fixing – Affix the rangehood with
the 4 M screws from inside the cabinet.
Electrical connection – The electrical
tension must correspond to the tension
noted on the label placed inside the
rangehood. Connect the electrical plug,
where provided to an easily accessible
outlet in conformity with local standards in
force. Where an electrical plug is not
provided (for direct connection to
electrical network) place a standards
approved bipolar switch with an aperture
distance of not less than 3mm
(accessible) from the contacts.
Operation – The control panel is situated
on the front of the rangehood and
equipped with 3 fan speeds. Use the
highest speed 3 for situations of high
level vapour concentration in cooking. It is
advisable to switch on the fan at least 5
minutes prior to cooking and leave it in
operation for approximately 15 minutes
after cooking has terminated.
The slide control light switch is located
above the fan control. Slide across to
switch on.