Kleenmaid RH9 - Manual (Page 5)

4
Hood Description -
Fig. 1
1) Control panel
2) Motor speed button
3) Operating light
4) Light button
5) Exhaust grate
6) Work-light
Use
Two systems are available:
Exhaust version
The air is vented outdoors by a duct
which must be connected to connect-
ing ring A (Fig. 2).
For 90cm. hood
Check if the internal shutter S are opened
before using the hood (Fig. 2).
Attention!
If the hood is supplied with carbon filter,
then it must be removed.
Filter version
The air is filtered through a carbon filter and
recirculated into the room through the grat-
ing on the lower side of the chimney.
This version is used when there is no ex-
haust duct for venting outdoors or when it
is impossible to install one.
To use the hood in this version, proceed as
follows:
— If no filter is supplied with the hood, ask
the technical assistance service or the
manufacturing company for one and
specify the hood model.
— Remove the grease filters (Fig. 10).
— To install the filter, fit it in the seat at the
front and fasten it at the back with the
two hooks B (Fig. 3).
For 90cm. hood
Attention! Close the shutter S before using
this version of the hood (Fig. 3).
— Refit the grease filter.
Installation
When installed, the hood must be not less
than 65 cm. above electric burners or 75
cm. above gas or mixed-fuel burners. (h,
Fig. 4).
In the vented exhaust version the fumes
outlet duct must be 120 mm. in diameter.
In the horizontal runs the duct must be
slightly slanted (about 10°) and directed
upwards to vent the air easily from the room
to the outside.
Electric connection
Before completing any connection, make
sure the house voltage corresponds with the
voltage indicated on the label affixed inside
the hood
It is advisable to call a qualified technician
to make the electrical connection.
Appliance fitted with plug.
Connect it to a socket which conforms with
current regulations.
If you intend to connect it directly to the elec-
tric mains, remove the plug and fit an ap-
proved bipolar switch with a minimum con-
tact opening of no less than 3mm.
If the plug is not accessible once it has been
inserted in the socket, it will however be
necessary to fit an approved bipolar switch
with a minimum contact opening of no less
than 3mm.
Appliance without plug
Fit an approved plug or an approved bipo-
lar switch with a minimum contact opening
of not less than 3mm.
The manufacturers are not liable for any
problems caused by the user’s failure to
observer the above instructions.