Kleenmaid MENHIR - Manual (Page 9)

8
A
B
C
D
INSTRUCTION ON MOUNTING AND USE
Description of the hood - Fig. 1
1 Control panel
2 Grease filter
3 Grease filter release handle
4 Halogen lamp
5 Vapour screen
6 Telescopic chimney
7 Air outlet (used for filter version only)
Operation
Description of control panel and hood operation
A. on/off light switch
B. on/off aspiration switch and minimum power
selection
B+C. medium power selection aspiration switch
B+D. maximum power selection aspiration switch
Use the high suction speed in cases of concentrated
kitchen vapours. It is recommended that the Rangehood
suction is switched on for 5 minutes prior to cooking and
to leave in operation during cooking and for approximately
another 15 minutes after terminating cooking.
Maintenance
Prior to any maintenance operation ensure that the
Rangehood is disconnected from the power supply.
Cleaning
The Rangehood should be cleaned regularly internally
and externally.
For cleaning use a cloth moistened with denatured alcohol
or neutral liquid detergents. Avoid abrasive detergents.
Warning:
Failure to carry out the basic standards of the cleaning of
the Rangehood and replacement of the filters may cause fire risks.
Therefore we recommend observing these instructions.
Grease filter
This must be cleaned once a month using non aggressive detergents,
either by hand or in the dishwasher, which must be set to a low
temperature and a short cycle.
When washed in a dishwasher, the grease filter may discolour slightly,
but this does not affect its filtering capacity.
To remove the grease filter, pull the spring release handle (f) - (Fig. 2).
Charcoal filter (filter version only)
It absorbs unpleasant odours caused by cooking.
The charcoal filter can be washed once every two months using hot
water and a suitable detergent, or in a dishwasher at 65°C (if the
dishwasher is used, select the full cycle function and leave dishes
out).
Eliminate excess water without damaging the filter, then remove the
mattress located inside the plastic frame and put it in the oven for 10
minutes at 100° C to dry completely. Replace the mattress every 3
years and when the cloth is damaged.
Remove the filter holder frame by turning the knobs (g) 90° that affix
the chimney to the Rangehood (Fig. 3).
Insert the pad (i) of activated carbon into the frame (h) and fit the whole
back into its housing (j).
Replacing lamps - Fig. 4
Firstly check that the lamps are well cooled prior to replacing them.
Use a small screwdriver as a lever on the borders of the lamp in order
to remove the lightbulb.
Unthread the connector A.
Slide out the lightbulb to be replaced and replace with a new 12V 20W
30° Ø35 12V GU4 PHILIPS STANDARD LINE code 425409.
Carry out the replacement and mount the new lightbulb by following
instructions in the reverse.
If the lights do not work, make sure that the lamps are fitted
properly into their housings before you call for technical
assistance.
Caution
The appliance is not intended for use by young children or infirm
persons without supervision.
Young children should be supervised to ensure that they do not play
with the appliance.
Do not use the Rangehood where the grill is not correctly fixed! The
suctioned air must not be conveyed in the same channel used for
fumes discharged by appliances powered by other than electricity.
The environment must always be adequately aerated when the
Rangehood and other appliances powered by other than electricity
are used at the same time. Flambé cooking with a Rangehood is
prohibited. The use of a free flame is damaging to the filters and may
cause fire accidents, therefore free flame cooking must be avoided.
Frying of foods must be kept under close control in order to avoid
overheated oil catching fire. Carry out fumes discharging in accordance
with the regulations in force by local laws for safety and technical
restrictions.